Sign in

no post, no beep, no display. where would you start??

Solvedmotherboardnew-buildpost4 replies · 139 views · started
Reply
Accepted solution by Ada I. — yeahhh on a first boot with new DDR5 platforms, memory training can take several minutes with a black screen and the DRAM LED on. Leave it…
  1. Mila
    @lucky_fiddler

    ok weird one i just finished my first build. Everything lights up, the fans spin, but theres no display and the DRAM debug LED on the B650 board stays solid.

    I've reseated the RAM twice and checked the 24-pin and CPU power cables. I'm terrified I bent a pin or fried something. What's teh next thing to check? Everything else seems right: the PSU switch is on, the case fans spin, and the motherboard RGB is doing its thing. I just can't get any picture or beep out of it.

    1
  2. Joon Ziegler
    @joon_heap

    uhh which slots are teh RAM sticks in, counting from the CPU? ??

    11 0 helpful
  3. Mila
    @lucky_fiddler
    in reply to @joon_heap

    Sticks are in slots one and two. The mnaual says A2 and B2. Moving them now. idk what else to say tbh

    25 1 helpful
  4. Yusuf Ueda
    @yueda
    in reply to @lucky_fiddler

    For a VGA LED, plug the monitor into the graphics card, not the motherboard, and confirm all PCIe power cables are fully seated. lmk how it goes

    1 0 helpful
  5. Ada I.
    @ada_cipher
    Accepted solution

    yeahhh on a first boot with new DDR5 platforms, memory training can take several minutes with a black screen and the DRAM LED on. Leave it alone for at least 10-15 minutes before assuming it's dead.

    1 9 helpful

Reply to this topic

Sign in or create an account to reply.