Sign in

my phone works on every computer except mine 馃

device-managerusbwindows38 replies 路 693 views 路 started
Reply
  1. Greta D.
    @gdalton_15

    This is driving me up the wall lol My phone was fine yesterday 馃う Today, nothing:

    I tried two cables and three ports. Sometimes it connects for a few seconds and then drops off again with teh disconnect sound. I havent installed anythnig new that I know of. Is it possible the port itself died? My worst fear is that something on the motherboard is failing, because some of my other USB devices act a little flaky too. Is there a way to tell a bad port from a bad device?

    thinking

    0
  2. Yusuf
    @yusuf_quiet

    yeahhh if it fails on every port of this PC but works elsewhere, check Event Viewer under Microsoft-Windows-Kernel-PnP for the devices errors around the time you plug it in. hope that helps :)

    1 0 helpful
  3. Esme Iqbal
    @night_shed-2io

    btw mods can we pin this thread :)

    0 2 helpful
  4. Yuki Costa
    @routerpilot

    lol same thing happened to me descriptor Request Failed means the device didn't answer Windows properly duirng setup, sooo it's usually power or signal, not drivers. Plug it directly into a rear motherboard port, not a hub or front panel, and try again.

    34 0 helpful
  7. Yuki Costa
    @routerpilot

    make a backup before u touch teh thermal paste, learned that the hard way hope that helps :)

    0 1 helpful
  10. Malik
    @malikr495

    @routerpilot nah thats not it, phone has nothing to do with it. spent since tuesday on deivce-manager and im still not done just my 2 cents

    12 0 helpful
  12. Yuki Costa
    @routerpilot
    in reply to @routerpilot

    btw unrelated but anyone elses coffee machine also judging them today, make a backup before u touch the BIOS, learned that the hard way

    2 0 helpful
  14. Yusuf
    @yusuf_quiet

    @routerpilot works on paper, not in real life but hey ymmv

    2 0 helpful
  15. Caleb
    @packethound

    Shut teh PC down completely, unplug teh power cable for a minute, then boot. This clears teh USB controller state and fixes a surprising number of these.

    1 0 helpful
  16. Esme Iqbal
    @night_shed-2io
    in reply to @packethound

    if the a robot vacuum draws a lot of power, a bus-powered hub or a long cable can starve it. try a pwoered hub or the shortest cable u own. fingers crossed 馃

    2 5 helpful
  18. Esme Iqbal
    @night_shed-2io

    try turning off the cable first, fixed it for me

    3 0 helpful
  19. Esme Iqbal
    @night_shed-2io

    yeahhh pro tip: write down what u change. i didnt and had to redo phone from scratch fingers crossed 馃

    5 0 helpful
  20. Yuki Costa
    @routerpilot

    for me it was teh cable. swapped it and boom, fixed, this, so much this good luck man!

    1 0 helpful

Reply to this topic

Sign in or create an account to reply.