"NO SIGNAL" SINCE TURNING ON VRR. HOW DO I GET THE PICTURE BACK??

oh ive been there lol boot into low-resolution mode: with the console fully off, hold teh Xbox button and the Eject button (or teh pair button on consoles without a disc drive) until you hear a second beep about 10 seconds later. it starts at a low resolution so u can fix teh video settings. lmk how it goes

bump 🤷 still happening with turning for me worked for me anyway 🤷

hmmm any update on this?, ok this thraed just saved my weekend

make a backup before u touch the thermal paste, learned that teh hard way. which version are u on?? worked for me anyway 🤷

oof make a backup before u touch the cable, learned that the hard way

have u checked your hdmi settings? mine were reset after an update

hmmm exact same thing happened to my mac last month hope that helps :)

ehh idk man that sounds like bad advice tbh

ahh classic have u checked your hdmi settings? mine were reset after an update worked for me anyway 🤷

hmmm bump. still happening with display for me

which version are you on?

oh also i come back to this thread every week just for the drama. try turning off the default config first, fixed it for me

ok but dumb question but how do i even check the cable ?

If u use a soundbar or capture card in between, connect teh cnosole straight to the display as a test. Passthrough devices often dont support every mode the console can output.

oof for me it was the fan curve... swapped it and boom, fixed hope that helps :)

+1 same here

oh ive been there lol pro tip: write down what u change. i didnt and had to redo hdmi from scratch fingers crossed 🤞

ok update: did what @ava.lindqvist40 said and its fine now u guys are the best!!!

@sara_proxy did u ever fix it? ?