Sign in

my monitor with speakers has picture but no sound since the forceware driver 81.85 certified update

Solvedaudiogpuhdminvidia8 replies · 231 views · started
Reply
Accepted solution by Tess Grant — ok so if the HD audio device shows a yellow mark, uninstall it in Device Manager (tick delete the drievr software if offered), then…
  1. Yara
    @ember_probe

    since updating the graphics driver my monitor with speakers gets no audio over HDMI at all.

    USB Audio Device Properties

    USB Audio Device Properties
Device status:
This device cannot start. (Code 10)

{Operation Failed}
The requested operation was unsuccessful.

    I tried another HDMI cable, another port, and restarting the monitor with speakers. In Sound settings the HDMI device doesnt even appear, and in Device Manager I dont see a high definition audio device for teh GPU anymore 😅 It worked yesterday on the old ForceWare Driver 81.85 Certified. Help? I am starting to suspect teh installer did smth odd, because nothing else changed. The monitor with speakers itself works fine with a game console on teh next input.

    4
  2. Ines Weber
    @ines.weber8

    check the projectors input settings... some TVs and receivers renegotiate audio formats after a driver change... power-cycling the projector with the PC on, or changing teh TVs HDMI audio mode to PCM, can bring teh endpoint back. lmk how it goes

    nothing is more permanent than a temporary workaround

    0 2 helpful
  4. Kenji B.
    @kenjib296

    lol same thing happened to me open the classic sound panel with mmsys.cpl, right-click teh empty area, enable Show Disabled Devices and Show Disconnected Devices. A disabled HDMI endpoint wont appear in the modern Settings page. good luck man!

    rgb adds +10 fps everyone knows that

    5 4 helpful
  5. Tess Grant
    @framebuilder
    Accepted solution

    ok so if the HD audio device shows a yellow mark, uninstall it in Device Manager (tick delete the drievr software if offered), then reinstall teh GPU package with the audio component selected. worked for me anyway 🤷

    lol

    13 7 helpful
  6. Erik
    @esato

    for me it was the extension... swapped it and boom, fixed hope that helps :)

    19 0 helpful
  7. Lars N.
    @threadtrace-1t1

    ive seen Express install skip HDMI audio only when the previous install had it unticked. A clean install is the surest way to reset that. but hey ymmv

    3 9 helpful
  8. Lars N.
    @threadtrace-1t1

    hmmm dumb question but how do i even check the firmware ??

    2 6 helpful
  9. Yara
    @ember_probe
    in reply to @framebuilder

    @framebuilder omg finally enabling it in mmsys.cpl plus power-cycling teh monitor with speakers did it. HDMI audio is back with ForceWare Driver 81.85 Certified .

    1 0 helpful

Reply to this topic

Sign in or create an account to reply.